 Most viewed - Bean's Gallery |
712 views
|
|
Conversion test successful707 views10.44kOhm instead of 15kOhm
|
|
Step 05: fascia panels707 viewsremove the two fascia panels
|
|
Step 06: light distributors703 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegs
|
|
Step 03: tacho and speedo needle701 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)
|
|
Step 01: retaining tabs top (3)694 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent cover
|
|
683 views
|
|
14 drawer cabinet681 views
|
|
672 views
|
|
654 views
|
|
tacho amp circuit651 viewscircuit to change a 5V square wave signal to a high voltage spike signal to run tachometers which ran of the coil -
|
|
10krpm custom fascia in motion645 views
|
|
rpm simulation on OEM cluster643 views
|
|
Step 02: retaining tabs bottom (3)635 viewspush down on the 3 retaining tabs on the bottom (best start on the side) to remove the transparent cover
|
|
632 views
|
|
|
|
