 Most viewed - User galleries |
Step 12: resistor R2 (15k Ohm) partialy desoldered738 viewsresistor R2 (15k Ohm) partialy desoldered
|
|
736 views
|
|
Water/Oil cutout dimensions729 viewsWidth 79.7mm; Height 15.7mm
|
|
Step 07: circuit and motor revealed727 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.
|
|
Conversion test successful723 views10.44kOhm instead of 15kOhm
|
|
723 views
|
|
Step 05: fascia panels719 viewsremove the two fascia panels
|
|
Step 06: light distributors715 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegs
|
|
Step 03: tacho and speedo needle711 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)
|
|
711 views
|
|
Step 01: retaining tabs top (3)708 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent cover
|
|
693 views
|
|
14 drawer cabinet689 views
|
|
680 views
|
|
tacho amp circuit665 viewscircuit to change a 5V square wave signal to a high voltage spike signal to run tachometers which ran of the coil -
|
|
| 528 files on 36 page(s) |
 |
3 | |
|
|
|
|
|
|
|
|
|
|
|
